scuffing
英 [ˈskʌfɪŋ]
美 [ˈskʌfɪŋ]
v. 磨损; 磨坏; 拖着脚走
scuff的现在分词
现在分词:scuffing
柯林斯词典
- V-ERG (使)磨损;(使)磨坏
If youscuffsomething or if itscuffs, you mark the surface by scraping it against other things or by scraping other things against it.- Constant wheelchair use will scuff almost any floor surface...
任何地板上经常有轮椅走动几乎都会有所磨损。 - Molded plastic is almost indestructible, but scuffs easily.
注塑几乎弄不坏,但是容易磨损。
- Constant wheelchair use will scuff almost any floor surface...
- VERB 拖着脚走
If youscuffyour feet, you pull them along the ground as you walk.- Polly, bewildered and embarrassed, dropped her head and scuffed her feet.
波莉既困惑又尴尬,低下头拖着脚走开了。
- Polly, bewildered and embarrassed, dropped her head and scuffed her feet.
双语例句
- The scuffing resistances of three phosphate coatings of manganese are evaluated in a MQ-800 four ball tester equipped with a new wear sample holder.
在MQ&800四球试验机上装配了一种新的磨损试验夹具,评价了三种磷酸锰盐涂层的抗擦伤性能; - The experimental results showed there exists influence of the oil temperature on the scuffing resistant.
试验结果表明:供油温度对摩擦副的抗咬死性能有较大的影响。 - Numerical investigation on interaction of axial and lateral response for super-long pile The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing.
轴-横向荷载作用下超长桩数值模拟为了避免划伤,轴承上的最大负荷应该总是小于其卸载负荷。 - Tess twisted her feet to make a scuffing noise.
苔丝缠绕着她的两只脚发出摩擦的声音。 - Research of Test on Gear Scuffing and Monitoring Technique
齿轮胶合的试验研究及其监测技术 - Standard test method for scuffing load capacity of gears
GB/T13672-1992齿轮胶合承载能力试验方法 - The temperature effect of scuffing in sliding contact of steel is explored from the point of view of frictional temperature.
作者从摩擦温度的观点考察了钢在滑动接触中擦伤的温度效应。擦伤试验是在环-块试验机上进行的。 - They are the scuffing bricks and moder of the nests.
他们是搬运砖块与筑巢的专家。 - The working condition and the form of scuffing failure of valve-valve seat pair are introduced. The method of valve-valve seat tribology designing is provided.
介绍了气门-气门座摩擦副的工作状况和失效形式,提出了气门-气门座摩擦学设计的方法; - Hot load and mechanical load coupling make piston to produce crackle, piston-ring glued and scuffing of cylinder bore and so on.
热负荷和机械负荷耦合将导致活塞产生裂纹、活塞环胶结以及拉缸等。
